Water sources on private subsidiary plots
In rural areas, and giving the main sources of water are still wells. They extract water from the centrifugal, vortex and electromagnetic pumps, which can take water from a
depth of 7 m and pick it up to a height of 20 m. The pump is installed in both private wells and in open areas, placing them in wooden boxes, covered with roofing material or
sheet-iron.
An electric pump consists of two main parts: the motor and blade of a centrifugal pump. Impeller with the blades of the centrifugal pump is enclosed in the body and is connected
to the motor shaft.
During the rotation of the impeller water, fill the pump, centrifugal force is thrown out of the body, made in the form of a snail, a pen stock, and served in a tank or a hand.
During rotation of the impeller in the intake pipe pump creates a vacuum, through which water is continuously fed into the suction pipe. Centrifugal pumps can operate only if
the impeller, and hence the suction pipe filled with water. Therefore, to keep the water inside the pump when it stops at the end of the suction pipe mounted receiver with a
check valve. If the pump starts to work the first time or after repair, the pump housing pre-flood water.
In addition to the Taco 006, the rural population uses pumps vibrating. Their operating principle is based on the use of electromagnetic waves transmitted by the valve-fin. At
relatively low power consumption (250 watts) and small mass flow of the pump is about 1,5 m3 / h at full height of 20 m.
